Hey Fritz
This Stop message, also known as Stop 0x50, occurs when requested data is not found in memory.
The system generates a fault, which normally indicates that the system looks for data in the paging file.
In this circumstance, however, the missing data is identified as being located within an area
of memory that cannot be read to disk. The system faults, but cannot find, the data and is unable to recover.
Faulty hardware, a buggy system service, antivirus software, and a corrupted NTFS volume can all generate this type of error.
The best thing to do, is to reset your BIOS to safe/default settings before doing a clean
install on a formatted harddrive, then when you are done, you can tweak your BIOS settings one by one.
Cheer's
/BC
Source : h**p://www.microsoft.com/windows2000/techinfo/reskit/en/prork/prhd_exe_duol.htm
in my PC. When is full installed, i can switch this 2 settings enable (Bios shadow and Video shadow) only in the Install-modus i must disable this.
Linear Mode
