When I try to burn using a Yamaha 6x4x16 burner, it seems to go just fine, then I get the following errors. Any suggestions/advice would be appreciated.
The scsi card is an Adaptec 2940.
Nero Version: 5.5.7.2
Recorder: <YAMAHA CRW6416S> Version: 1.0c - HA 2 TA 0 - 5.5.7.2
Adapter driver: <aic78xx> HA 2
Drive buffer : 2048kB
Bus Type : default (0) -> SCSI
CD-ROM: <TOSHIBA CD-ROM XM-5302TA>Version: 2095 - HA 0 TA 1 - 5.5.7.2
Adapter driver: <atapi> HA 0
Bus Type : default (0) -> ATAPI
=== Scsi-Device-Map ===
DiskPeripheral : SAMSUNG SV0844A atapi Port 0 ID 0 DMA: On
CdRomPeripheral : TOSHIBA CD-ROM XM-5302TA atapi Port 0 ID 1 DMA: Off
DiskPeripheral : WDC WD136AA atapi Port 1 ID 1 DMA: Off
CdRomPeripheral : YAMAHA CRW6416S 1.0c aic78xx Port 2 ID 0 DMA: ?
7:32:00 PM #15 mmc -1119 File Writer.cpp, Line 321
Track following error
7:32:00 PM #16 Text 0 File ThreadedTransfer.cpp, Line 219
all writers idle, stopping conversion
7:32:01 PM #17 Text 0 File ThreadedTransfer.cpp, Line 213
conversion idle, stopping reader
8:02:27 PM #18 CDR -201 File WriterStatus.cpp, Line 186
Invalid writestate
8:02:27 PM #19 TRANSFER -18 File WriterStatus.cpp, Line 186
Could not perform EndTrack
8:06:35 PM #20 Phase 38 File dlgbrnst.cpp, Line 1436
Burn process failed at 2x (300 KB/s)
8:06:35 PM #21 Text 0 File Scsicmd.cpp, Line 371
SCSI not using temporary buffers
20 out of 20 temporary buffers allocated
8:06:37 PM #22 SCSI -1080 File Cdrdrv.cpp, Line 1207
SCSI Exec, HA 2, TA 0, LUN 0
Status: 0x04 (0x01, SCSI_ERR)
HA-Status 0x00 (0x00, OK)
TA-Status 0x02 (0x01, SCSI_TASTATUS_CHKCOND)
Sense Key: 0x02 (KEY_NOT_READY)
Sense Code: 0x3A
Sense Qual: 0x02
CDB Data: 0x1E 0x00 0x00 0x00 0x00 0x00
Sense Data: 0x70 0x00 0x02 0x00 0x00 0x00 0x00 0x0A
0x00 0x00 0x00 0x00 0x3A 0x02
Threaded Mode
