My new LiteOn won't share IDE channel!

[rodeoflip]

I recently replaced my old Teac 4x2x32 with a new LiteOn 40125w. My old Teac happily shared IDE channel with an old Maxtor 1.1gb disk (I use that disk to transfer data between computers I don't have network access to. Yes, it is the only way for me atm).

The LiteOn does not like to share the IDE channel. I tried switching between master/slave/cable select. But it only results in the cdrw not willing to burn nor read more than the first file/folder on cds!

Is there any other solution than buying an extra IDE controller? the cdrw does a great job as long as the hdd isn't connected.

[Beta Spanky]

I had a friend with some trouble with the Liteon. He had to update the firmware on the burner.

Your best bet is to look around the liteon website and see if this is a known problem.

[stumuzz]

Hi rodeoflip,
try this site :
ht*p://forum.cdfreaks.com/
got some good info on the liteon and other burners.
Stumuzz.

[kamikazee]

as old as that drive is does it even support udma/dma???? Make sure it is enabled in the device manager and bios...Does the bios pick-up your drive???
dma/udma some do not like to be mixed with none dma/udma

[Jupiter2k]

Most likely its MB BIOS issue

My CDRw will not recognise by my MB if it's slave to the primary channel !

but no problem as Master on the secondary channel ?

Don't know why ?

it work!
Ask your friend to swap the drive between Master/slave may help!

My friend has a new CDRW only work if he use the 40 pin IDE cable ..but having burning problem with 80 pin cable,this can be
another possibility as well

[greasemonkey]

Whats on your primary IDE channel and have you tried switching the drive to it?

[rodeoflip]

My mb recognizes all 3 hdds and the cdrw correctly in the bios. It is when I'm trying to use the cdrw in WindowsXP I got problems.

I tried changing the connection settings in the bios to see if it made a difference. It did not.

I already got 2 hdds on my primary channel. And I would prefer not to swap them, because the primary channel supports udma/66, and the second only udma/33.

[skloo77]

bios is 1 thing if your system is of the older generations.