power led wires on case

[adams]

ok i have an ecs mobo and a dynapower case (building it for my dad). the power led has a three pin connector, but the spot where it should go on the mobo is only made for two pin connector. what do i do about this?

(yes i'm sure i have the wires in the right spot). the case doesn't come with any documentation and their website sucks. i have referred to the mobo book, but as i said it only shows for a two pin connector.

thanks.

[kamikazee]

these are on the wires itself and the holder they are in do like I had to do, I imagine you have a space between the two wires in the case, then carefully remove one of the pins and put it in the empty hole, the pins will pull out, there is just a very small tab holding it in place.

[adams]

thanks, just did that after i thought about it for a while and looking through my old computers trying to find a 2pin connector (didn't have any luck at that).

closing thread now since the problem is solved.