|
Ok, this is driving me nuts. Both my 80 gig 7200 rpm and 30 gig 5400 rpm Maxtor drives check out find when I run Maxtor's diagnostic program on them, but, I'm getting a hell of a lot of errors. Three times in the past few hours my pc has rebooted on it's own, not even a bsod to be helpful. When it reboots, my 30 gig drive isn't detected in the bios, i have to shutdown the pc and cut it back on for the drive to be picked up. I'm getting a lot of CRC errors on my 80 gig drive too. The 30 gig drive is around two years old, the 80 gig is around 3-4 months old tops. I know it isn't my motherboard either, because I've tried three different IDE controllers and they all have the same problems. UDMA is enabled on both drives fine as well. Any ideas? I'm at my wits end here... /me posts this before windows decides to reboot again
|
Threaded Mode
