|
Hi guys,
I just ordered a P4 1.6A/ Abit TH7-II/Rambus combo. I understand that some of the i850 mainboards only have 400 Mhz DR Clock gens. I'd like to get at least 133 Mzh(533) FSB, so I obtained 2 sample parts thru my company, TI 533 Mhz DRCGs.
I have soldered a little, but not sure if I should try something like this?
Would you guys install the mainboard 1st and see if it will handle 133? Or should I get the parts replaced 1st? If so, where would I go to find someone who could solder the new parts on, computer repair shop, electronics repair, any suggestions?
Any comments or tips welcome, if IC/PCB soldering isn't that hard, give me some reference stuff, what kind of Soldering Iron, Solder, any other stuff like that.
Thanks All,
Mike G
Edit; s**t, just got the DRCGs in the post, these suckers are small, don't think I could solder these, hope someone can suggest a place to go get it done
|
Threaded Mode