|
@roadworker....That might be the problem, in Computer Management it shows the following IDE ATA/ATAPI controllers:
Intel® 8280 1EB Ultra ATA Starage Controllers
Intel® 8280 1EB Ultra ATA Starage Controllers
Primary IDE Channel
Primary IDE Channel
Secondary IDE Channel
Secondary IDE Channel
The first Primary Channel shows Device 0, Transfer Mode: DMA if afailable and Current Transfer Mode: PIO Mode
Device 1 Current, Not Applicable
The second Primary Channel shows Device 0, Transfer Mode: DMA if available and Current Transfer Mode: Ultra DMA Mode 5
Device 1 Current, Not Applicable
The first Secondary Channel shows the same as the first Primary Channel
The second Secondary Channel shows Device 0, Transfer Mode: DMA if available and Current Transfer Mode: Not Applicable
Device 1 Current, Not Applicable
I'm running a Asus P4C800-E Deluxe Main Board with on board raid.
I have 1 SATA hard drive, 1 Plextor PX 708A DVDR and 1 Plextor 52x CDRW.
I tried changing the PIO channels to DMA and re-booted but it came up the same. I'm sure that it will have to be set in the bios but I'm not sure how it needs to be.
------------------------------
@rikytik It shows that I'm burning at 8X
|