I want to run vnc from a command using the following syntax (see below) so that I would not have be sitting at my computer when the "runas" command prompts me for my password. I have not been successful in finding a workaround for the runas command, since it won't accept a password parameter. Any ideas?

cmd /c echo [password] | runas /user:[username] [vnc.exe]

Thanks,
cappaberra

I found two possible options, but I'm sure there must be other ways...

Scripting:
http://itresources.brainbuzz.com/Tec...1199&CatID=295

Third party tool:
http://www.mast-computer.de/software...p/software.htm

Hopes this helps. Of course your situation must be allowing any of these solutions.

Why is this in Web Development Wouldn't you have more replies ifthis was in Software support?

well, the only reason why i put it here, was because this problem was part of a web based script i was working on... i'll get back to this thread once i go through your suggestions. thanks :)

-CaP