Anyone know if its possible to convert a 2 wire push button from a 4 wire clicky type of switch?

Both are AT power supplies. But I wanna keep the push button instead of the clicker.... :rolleyes:

Ok here is what to do. There should be 4 wires...White/Black and Blue/Brown. The White/Black are power in Neutral/Hot. The Blue/Brown are power out again Neutral/Hot. If you only have a single pole switch then connect the White to Blue permanently and put the Switch between the Black and Brown wires. The switch will then turn on/off the Hot lead.

Crowdirt U rock!!! Thamks very much!!! :D