Hi i have just finish installed the sp1 and soo far there is no prob.

the only thing i see so far is that the for testing purposes
is back for me.after installing the last built 1089 to a clean install it wasent there but now its back hmmmm..

Windowns media player v9 2773 is working :-) i begin to like that now.


PittPull

hi, just installed the 1090 , work great , i hope soon have it in my natual language ,

I installed the sp1 1090, working good and I don't have for testing purposes.

No Problems her.........

Installed great.....

I've been able to load SP up to 1086. !089 and 1090 give me this error> _http://mywebpages.comcast.net/HotRod/error.gif Any way to get around this

Thanks

just get that file from someone

i can give u the one for 1089 dont have 1090 yet

@hotrod - I can email it to you - it is 264 KB
There are 2 other update files as well
update.exe and update.ver
the update.msi is old - the other two are dated Aug 5
Can send those too, Need an address though

I have just found that 'cryptographic services' is listed as a component service
For the description of the service it says:
If this is disabled it might cause that error.
To check go to Control Panel/Administrative Tools/ Component Services and under the status it should say 'started'
It might have been disabled during your last successful SP1 update
Just an idea :)

Thanks all,
Services are running. If you would send the files will give that a try


Thanks

Forgot to check logs, this is what it says

Catalog Database (736) The database page read from the file "C:\WINDOWS\System32\CatRoot2\{F750E6C3-38EE-11D1-85E5-00C04FC295EE}\catdb" at offset 2007040 (0x00000000001ea000) for 4096 (0x00001000) bytes failed verification due to a page checksum mismatch. The expected checksum was 2723619549 (0xa25722dd) and the actual checksum was 576135901 (0x225722dd). The read operation will fail with error -1018 (0xfffffc06). If this condition persists then please restore the database from a previous backup.

GOt it, just deleted that folder and everything went well



Last edited by HotRod at Aug 9 2002, 04:08 PM

Found something about this on iexbeta discussing "For Testing Purposes"

I've tried it with sp1 1090 and it works fine. "For Testing..." is gone



Last edited by MinnesotaKid at Aug 10 2002, 08:14 PM

used the ol bat file n "for testing purposes" was gone.
if u ran this file on n ol sp1 build,
it will tell ya that there is no such file.
no worry just reboot n its gone.

[hide]@echo off
echo Remove sp1 build no from desktop (xpsp1) by wet paper bag (and bophoe)
echo.
echo this will remove "Testing purposes only" and build no from your desktop
pause
echo.
reg delete HKLM\SOFTWARE\Microsoft\SystemCertificates\CA\Cert ificates\FEE449EE0E3965A5246F000E87FDE2A065FD89D4 /f
reg delete HKLM\SOFTWARE\Microsoft\SystemCertificates\ROOT\Ce rtificates\2BD63D28D7BCD0E251195AEB519243C13142EBC 3 /f
echo.
echo all done, reboot for changes to take effect
pause[/hide]

thanks keru

Just installed 1090 and so far so go.......